Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Posted in:
  • 2. Dezember 2018 at 6:59 #42468

    I’m having the same problem

    Raspberry Pi can't access Max2Play web interface

    I have re-imaged a couple times, everything works until Max2Play reboots. then I got nothing for web access. LMS still sees and controls the player.

    2. Dezember 2018 at 6:14 #42467


    I was unable to SSH into the other Max2Play device I re-imaged earlier this year,
    The Server Rpi does accept ssh access.

    All three of these units are running stock M2P software, so the default user/pw combo should work .

    26. Oktober 2018 at 6:46 #41666

    Just experienced this problem again. previously, after my post above, I was able to access my LMS Server, and play local content.

    tonight, with loss of WAN, the LMS page only partially loaded (nnn.nnn…:9000)and I couldn’t do anything.

    now that wan is back up, I was able to get the requested DEBUG, but the system is up, so is it still helpful?

    eth0 Link encap:Ethernet HWaddr b8:27:eb:e0:af:43
    inet addr: Bcast: Mask:
    RX packets:398345 errors:0 dropped:0 overruns:0 frame:0
    TX packets:343644 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:1000
    RX bytes:169301902 (161.4 MiB) TX bytes:106904905 (101.9 MiB)

    lo Link encap:Local Loopback
    inet addr: Mask:
    UP LOOPBACK RUNNING MTU:65536 Metric:1
    RX packets:84785 errors:0 dropped:0 overruns:0 frame:0
    TX packets:84785 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:0
    RX bytes:28271272 (26.9 MiB) TX bytes:28271272 (26.9 MiB)

    ### WLAN ###

    11. September 2018 at 20:09 #37807


    rebooted the Rpi. would ping but now not play anything via LMS nor allow web or ssh connection.
    rebooted again and there was only a ping response. the device wasn’t showing up in LMS.

    I have had a similar problem in the early days of using a Rpi with squeezebox (pre Max2Play days)
    and it ended up being a memory card problem. So that is what I will try this time.

Viewing 4 posts - 1 through 4 (of 4 total)