Rod

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Posted in:
  • 11. Januar 2021 at 20:23 #50579

    Hello, Autostart Squeezelite takes 1 minute to autostart after exiting from KODI. If I start Squeezelite manually using the GUI web interface then Squeezelite starts immediately. I have been using RPi3 no issues for 3 years. Issues started on RPi4.

    Operating Version 2.53 on RPi4B 4GB
    Squeezelite Max2Play v1.0.3 based on v1.8.7-999, Copyright 2012-2015 Adrian Smith, 2015-2017 Ralph Irving.
    KODI V18.7
    SqueezeServer 7.9

    Thanks, Rod

    15. Mai 2020 at 1:03 #48785

    Thank You grimmt for a solution!
    I also support M2P and was disappointed to find this basic feature broken in Pi 4
    I gave up on M2P and stopped spreading the word about the greatness of M2P because I was embarrassed.
    I moved over to a different OS but I have returned because of YOU!

    I also raised this issue APRIL 1 2020 AT 6:20 #48370.
    In forum [Announce] New Max2Play Image for Raspberry Pi 4.

    1. April 2020 at 6:20 #48370

    Hello,

    I’m a big fan of M2P RPi3. Before my question, I would like to share how to cool the Pi4 to 32 degrees Celsius.

    I use a heatsink and fan. The aluminium heatsink is 10mm finned and 3mm larger around the surface area of the cpu device. The epoxy glue is J-B Weld 8280 Original. The fan is a 80 mm Noctua NF-A8 5V. A 10 Ohm thermistor SG42 part# to additionally slow the fan. A jigsaw was used to cut circle out of the top and drilled some holes to mount the fan on a NESPI case. The project was 1.5 hours.

    **My question for RPi4.** On my TV (RPi3 version 2.50 works fine), however for RPi4 Jivelite does not autostart after Exiting KODI. The display is flashing the M2P command prompt. Stop and then Start Jivelite displays the Jivelite GUI again until Start and Exit KODI.

    I’ve tried several combinations of RPi4 versions of OS, KODI, Jivelite, and combinations of autostart for OS, Squeezelite, KODI, and Jivelite.

    I’ve searched the Forum for advice but haven’t found it, but also thinking I’m the only one with this issue because somebody would have posted for support. Thanks for your support.

    Rod

Viewing 3 posts - 1 through 3 (of 3 total)