wg035164

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Posted in:
  • 22. Mai 2019 at 10:39 #45471

    many thanks to el84 for sharing this circuit with us. Unfortunately the schematics is a bit blurred on the HP and I am not sure about some components. Just to be on the safe side: the transistors are BC338 and 546 and R1 is 33k ? For the I/O control do I really set the GPIO pin and not the respective port ? (as they are not the same)

    Also helpful would be the HW settings for the 2 GPIOs (pullup resistors, max. current, etc.)
    BR
    George

    • This reply was modified 2 years, 5 months ago by  wg035164.
    22. Mai 2019 at 10:06 #45470

    many thanks for your efforts. What I would like to see in this plugin besides rotary encoders, HW on/off switch and IR support would be a „HW mute“ button.

    BR
    George

    7. Mai 2019 at 11:10 #45304

    many thanks for your quick reply, in the meantime I had to send back my faulty display and must wait for a replacement. The error messages appear whether Jivelite is running or not. What I also saw was that when I tried to stop Jivelite I got the response „not successful, try kill“ but the application was stopped anyway and the kill option was not even presented. What I also discovered was that for the original Pi 7″ display I need an extra plugin for this touchscreen.
    Is the setting of the display in Jivelite itself then disregarded or what do I have to set there ?

    BR
    George

Viewing 3 posts - 1 through 3 (of 3 total)