Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • 8. November 2019 at 19:05 #47518


    I’ve tried that. Health checker reports:
    Internet: Connected
    CPU Load: 0.56
    SD Card Usage: 16%
    Temp CPU: 53.7
    Power Supply: OK

    Internet is cabled and on 311Mbps so speed not an issue. 🙂

    Set the code to blank, saved and re-entered it. Rebooted and even reset all the settings.

    I’m typing this in Firefox on the M2P desktop on the same Pi so connectivity is fine.

    Could it possibly be anything to do with the basic firewall in the router?

    Weird how it was fine out-of-the-box but not after. I can supply my activation code if that helps you?

    5. November 2019 at 17:22 #47481

    After initial install it was pre-populated with my licence code (same code as the paper certificate provided by Max2Play). It was then when I noticed it said „Activated“ in green. After the update it became de-activated. I linked my email to the licence code as suggested in the Wiki but this didn’t work either. I then set it back to the original licence code and it still doesn’t work. 🙁

Viewing 2 posts - 1 through 2 (of 2 total)