Forum Replies Created

Viewing 1 post (of 1 total)
  • 15. November 2017 at 19:26 #32495

    Hi everyone,

    I’ve tried to make a static IP both for Network and WiFi. When I made some changes to dhcpcd.conf file my result was as above : 4 IP address (two for Network,two for WiFi and all they were working!). I went through wpa_supplicant.conf files (they are two of them: one original in /etc/wpa_supplicant/ and second one, which is used by max2play, in /opt/max2play/ ) but nothing has got better. I’ve read some notes about raspbian jessie and found very simple solution.

    Only what you need to do is go to /etc/network/interfaces and change lines to this (addresses are only for example):

    # /etc/network/interfaces
    auto lo
    iface lo inet loopback
    #auto eth0 # managed by ifplugd
    #iface eth0 inet dhcp   <--- if you what to have static IP for Network hash this line and use dhcpcd.conf file to determine your IP
    #hwaddress ether 1a:64:b6:bf:36:37
    allow-hotplug wlan0
    auto wlan0
    iface wlan0 inet static #change dhcp to static
    address  #static IP for RPi
    gateway  #IP of your router
    wpa-ssid "NETWORK_SSID"
    wpa-psk "PASSWORD"
    #pre-up wpa_supplicant -B w -D wext -i wlan0 -c /opt/max2play/wpa_supplicant.co$ 
    #post-down killall -q wpa_supplicant  #hash last two lines 

    Now my RPi3 with M2P onboard is connecting with the same IP to WiFi everytime.

Viewing 1 post (of 1 total)