Raspi with watterott dispaly, Jivelite not showing after restart

Max2Play Home 2016 (en) Forums Max2Play Add-ons Raspi with watterott dispaly, Jivelite not showing after restart

This topic contains 1 reply, has 2 voices, and was last updated by  flysurfer premium 2 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • 17. September 2016 at 18:05 #23079

    Hi.
    I’m using the following hardware:
    Raspi 1
    Watterott 2.8″ touch display
    wired ethernet
    Max2Play version 2.3.4

    Jivelite appears on the display after reinstalling it, or after reinstalling the qvga touch skin, and works well so far.
    But after a restart, jivelite doesn’t show up.
    The web interface tells me it’s running, but I can’t see it on the display.
    When I try to stop and restart it via the web interface, I get the following error:

    JiveLite 0.1.0
    [0;33m20160917 16:02:15.743 INFO jivelite – JiveMain.lua:267 JiveLite version 0.1.0[0m
    [0;31m20160917 16:02:15.772 ERROR jivelite.ui.draw – jiveL_initSDL:204 SDL_Init(V|T|A): Unable to open a console terminal
    [0m

    I tried to update max2play to 2.3.6, but then the display doesn’t work at all.
    Any ideas?

    • This topic was modified 2 months, 3 weeks ago by  uhrheber.
    30. September 2016 at 10:49 #23262

    Hi,

    in the Settings / Reboot tab, could you remove the Autostart from “Autostart Desktop” and try again? Jivelite starts the desktop automatically if this is not running yet. Maybe the RPi 1 is too slow and gets confused by 2 Desktops starting at the same time.

    Regards,
    Stefan

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Register here