OLED on Audiophonics Kit

Max2Play Home › Forums › Max2Play Projects and Builds › OLED on Audiophonics Kit

Viewing 2 posts - 1 through 2 (of 2 total)
  • Back to forum
    Posted in: Max2Play Projects and Builds
  • neil premium
    12. Mai 2020 at 2:20 #48755

    Hello,
    Audiophonics Kit with PI-3, Sabre-V3, and OLED. All works very well with Ethernet, including music selection and OLED display. When set up with WiFi only, OLED stops displaying music selection information, and eventually displays „good bye“ and goes blank. Music continues to play and will allow selection changes, OLED continues to be blank. Change back to Ethernet and all works as it should.

    Any suggestions?
    Thanks in advance

    MarioM Moderator
    15. Mai 2020 at 14:59 #48794

    Hi Neil,

    The display probably works with a player ID, which is changed when you switch from Ethernet to Wifi. I would suggest looking in the OLED display config to see if there is a MAC address or IP somewhere.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Register here