Need help on New Allo Vana installation

Max2Play Home 2016 (en) Forums SD-Card Imaging and getting started Need help on New Allo Vana installation

This topic contains 2 replies, has 2 voices, and was last updated by  Heiner Moderator 7 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • 25. Januar 2018 at 21:53 #33653

    install seems Ok via browser on PC, but does not make any sound.

    I previously tried a Volumio image which made sound, but had a lot of sound glitches / interruptions, so I switched to Max2Play.

    It is installed, has cataloged and can see all the .flac files on my NAS via ethernet, but does not make any sound.

    I have spent a day going through every setting and nothing works.

    Is there a step by step troubleshooting guide?

    Colin

    25. Januar 2018 at 23:03 #33655

    Ok – I hammered on settings a bit more and now it makes sound, but plays for a few seconds and stops. Changing subwoofer mode to „none“ seems to be what fixed it but it is hard to know for sure, as I have changed so many settings and rebooted so many times.

    The logitech player interface seems incredibly unresponsive too, played from a browser on a PC on the same ethernet.

    Is there anything newer better which is supported by Max2Play?

    Sorry for the newb questions, but this is the „getting started“ Forum.

    Colin

    29. Januar 2018 at 10:56 #33715

    Hi Colin,

    The Vana Player install of Max2Play and its support is handled by Allo. I am sure they will be able to help you along the quickest for this build.

    Our main operating system is for the Raspberry Pi.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Register here