Reply To: RPi 3B+, Hifiberry AMP2 , Adafruit 3.5" – Display doesn't work

22. Januar 2019 at 15:41 #44019

Hello Heiner,

thank you for your answer.
I have allready tried several new images, as it is the only way to remove a display setup –> no improvement.

Is there experience at max2play, that 2 add-on boards won’t work fine, one of it the Adafruit 3,5″ display? Or is it maybe the 2×20 GPIO pin board, and the 2x13GPIO pin board might work?
Is there any other known solution, to have 2 add-on-borards working, e. g. another display.?

What is the safest way? Should I go to a display which uses the HDMI-connector of the Pi? –> honestly said ,there are also some nice displays available, especially 5″.
I also have another topic running concerning support of max2play for a 5″ display. –> Do you have an alternative, that this might work?

Thank you and regards,

Philip