Max2Play Home › Forums › Max2Play Add-ons › car media player ( accesspoint / Kodi question) › Reply To: car media player ( accesspoint / Kodi question)
Hi Heiner,
I have just exchanged PSU and made a new image.
What happens now is as soon as M2P boots up on the GUI page, I get
„Device is started in Automatic Accesspoint Mode. For security, only WiFi configuration is possible to connect Max2Play to your local network“.
I have just shut it down and fired it up again with another new image and now I can see it on my phones wifi page.
Please note it did ask me to update the image, this time I didnt..And it loaded the Accesspoint
However, it keeps trying to get the ip address and can’t so it goes back to the saved state, where then keeps trying, then back to the saved state etc etc.
The debug on the AP is this below, which, I’m no expert, but looks ok !…
#### DNSMASQ Installed ####
Status: install ok installed
#### HOSTAPD Installed ####
Status: install ok installed
#### WiFi Interface Installed ####
2
#### DNSMASQ Running ####
#### HOSTAPD Running ####
5 S 0 455 1 0 80 0 – 1543 – ? 00:00:00 hostapd
please note the above is using the same pi.
BUT
So far I have used different PI’s
Different power supplies
Different SD cards
Both driver options on the AP page.
I have updated M2P when I have burned the image and also not updated, and burned the imaged and updated, seems the not updated option works the best. It actually loads up the accesspoint.
So I’m now well and truely stuck. Hope someone can help…