Reply To: [NEW UPDATE] Pulsating sound with new Hifiberry Amp2

5. Dezember 2017 at 9:20 #32785

Hi all,

same issue for me.
Only Squeezelite is activated.
configured to hw:0
Squeezeserver also running on this pi3, connected via Wlan.
Have not yet tested if the other speaker (pi0w with justboom amp) is working correctly. Its located in the studio downstairs.

But the issue only starts after i upgraded from 2.44 to 2.45
Was working normally with a pi3 and Amp2

But it only happens on one channel. (the right one, if you look to the terminals)
Need to check if it is also happening while playing music, not tested yet, since it was so annoying that i pulled one cable to not destroy the expensive Klipsch Speakers.

Will try to flash the system again but again with v2.44