Reply To: Install M2P-244 w/o WPS

Max2Play Home 2016 (en) Forums Max2Play on Raspberry PI Install M2P-244 w/o WPS Reply To: Install M2P-244 w/o WPS

19. September 2017 at 21:40 #31408

Here is status after Automatic Setup fails. It’s displayed on the Wifi/LAN tab after the laptop wifi connection is switched back to „max2play“:

WiFi & Network configuration

Setup WiFi Started
2017-09-18 23:12:06|
Disable Accesspoint
insserv: Service dnsmasq has to be enabled to start service apache2
insserv: exiting now!
update-rc.d: error: insserv rejected the script header
ifdown: interface wlan0 not configured
ioctl[SIOCSIWENCODEEXT]: Invalid argument
ioctl[SIOCSIWENCODEEXT]: Invalid argument
0
OK
OK
FAIL
OK
OK
OK
No IP-Address could be received – WiFi NOT working correctly. Please check Network-ID and Passphrase!
Ignoring unknown interface wlan0=wlan0.
ioctl[SIOCSIWENCODEEXT]: Invalid argument
ioctl[SIOCSIWENCODEEXT]: Invalid argument
FAIL
OK
ioctl[SIOCSIWENCODEEXT]: Invalid argument
ioctl[SIOCSIWENCODEEXT]: Invalid argument
WiFi detected
insserv: Service dnsmasq has to be enabled to start service apache2
insserv: exiting now!
update-rc.d: error: insserv rejected the script header
Restarting hostapd (via systemctl): hostapd.service.
Restarting dnsmasq (via systemctl): dnsmasq.service.
Finished Please Click here Reload Page!

Status: WiFi USB adapter status is active. WiFi connection status is not active
(Only WPA/WPA2-Encryption possible)

Load WiFi Interface:
Network SSID:
Password:

List of available networks:
start scan

  • This reply was modified 3 years, 6 months ago by  Mike-97470.
  • This reply was modified 3 years, 6 months ago by  Mike-97470.