Max2Play Home › Forums › General Questions on Hardware and Max2Play Versions › Airplay problems › Reply To: Airplay problems
Hi bjarne,
Please try this command:
volume_range_db=dBvalue;
Set this dBvalue to use just a portion of the full range of
attenuation offered by a mixer. For example, if a mixer has a
minimum volume of -80 dB and a maximum of +20 dB, you might wish
to use only 60 dB of the 100 dB available. This might be because
the sound becomes inaudible at the lowest setting and unbearably
loud at the highest setting — indeed, many domestic HiFi
systmes have a volume copntrol range of just 60 to 80dB. Another
potential use might be where the range specified by the mixer
does not match the capabilities of the device. For example, the
Raspberry Pi’s DAC that feeds the built-in audio jack claims a
range of 106 dB but has a useful range of only about 35dB. The
setting allows you to specify the maximum range from highest to
lowest. The range suggested for the Raspberry Pi’s built-in
audio DAC, which feeds the headphone jack, is 35. Using it in
this case gives the volume control a much more useful range of
settings. If you omit this setting, the full „native“ range of
the mixer is used.