Reply To: Setting Volume with Encoder using Jivelite

Max2Play Home Forums Max2Play on Raspberry PI Setting Volume with Encoder using Jivelite Reply To: Setting Volume with Encoder using Jivelite

14. Januar 2016 at 22:50 #17864

Hi Heiner,

I have those parameters in my config.

The encoder changes the volume but it does not change the slider in Jivelite.

When I change the volume using the encoder the Jivelite slider does not move, however the volume changes and stays set while a song is playing until a few seconds before the end of the song at which time it reverts back to the volume set on the slider in Jivelite.

If I touch the encoder again the volume returns to the that which was previously set by the encoder but again only until a few seconds before the end of the currently playing song.

Regards,

Patrick